Sobo WP-5500 Aquarium Head Sump Motor, 3000 Lt/Hour

Power: 60 Watts
Voltage: 220V/50Hz
Maximum head-pressure capacity is 3.0 meters
It has a water capacity of 3000 liters per hour.
Size: 120 x 170 x 120 mm
Operated by being completely submerged in water
4 suction cups for fixing on the glass are included in the package.

High performance and durable aquarium head motor with ceramic shaft

Works with low noise

Used for water circulation in freshwater and saltwater aquariums

Attention:
Before touching the engine, be sure to disconnect the electrical connection.
Do not let the engine run dry.
Do not lift the device by holding the power cord.
For optimum cooling, place the engine underwater.
The power cord of this tool cannot be replaced.
If anything happens to the cable, you should not use the tool either.
Disconnect all electrical connections before putting your hands in water.
Care:

To clean the engine, remove the front plate and impeller.
Use a small brush or light water pressure to remove accumulated dirt.
Attention:

IF THE ENGINE DOES NOT WORK AS REQUIRED, FOLLOW THE STEPS BELOW
Check the breaker switch and other outlets to make sure there is power to the motor.
Important note:

Before touching the motor, be sure to disconnect the motor from the electricity.

Check whether there is any blockage in the discharge part of the engine and the pipe part.
Any moss build-up can be removed with a garden pipe.
Remove the inlet tube to access the impeller section.
Turn the rotor to make sure it is not broken or stuck.
Monthly maintenance will extend the life of the device.
Attention:

Pay attention to the fact that the electrical cable at the bottom of the electrical outlet is slightly drooping.
In case of any water contact, the water does not reach the engine, it drips down from the drooping ground.